Dascom T5040 Quick Start Guide - Manual (Page 10)

Installation Quick start guide
6
` Placing the printer Place the printer on a solid, flat, surface, ensuring that the printer is positioned in
such a way that it can not topple, and that there is easy access to the control panel
and paper input devices. Also ensure that there is enough space for sufficient ven-
tilation and for the printed output:
When selecting the printer location, observe the following additional instructions:
Never place the printer in the vicinity of inflammable gas or explosive substances.
■ Do not expose the printer to direct sunlight. If you cannot avoid placing the
printer near a window, protect it from the sunlight with a curtain.
■ When connecting a computer to the printer, make sure not to exceed the maxi-
mum cable length (see User guide on the Online CD-ROM, Technical Specifi-
cations).
■ Ensure sufficient distance between the printer and any heating devices/radia-
tors.
■ Avoid exposing the printer to extreme temperature or air humidity fluctuations.
Above all take care to avoid the influence of dust.
■ It is recommended to install the printer in a place which is acoustically isolated
from the workplace because of the noise it may produce.
Location Minimum space
Left and right side of the printer 1 cm
Top of the printer 2 cm
Rear of the printer to ensure sufficient ventilation 10 cm
to print on a DIN A4 sheet 12 cm
STOP
Quick Start-en.book Seite 6 Dienstag, 5. Dezember 2006 10:48 10