Dascom 7010 Compact Ethernet Board - Manual (Page 8)

Operating Instructions
8
Compact Ethernet Board
2. Changing the current network settings of the printer
To change the current network settings of the printer,
do the following:
2.1. Write the current printer IP in the BROWSER, that you have chosen.
Load by ENTER.
The following table is displayed on the screen:
2.2. If you want the DHCP server data to be used by the printer (IP address,
Subnet mask and Gateway settings), switch ON (check) DHCP еnable.
2.3. If you want to be used manually loaded static data ( IP address, Subnet mask
and Gateway), switch OFF (do not check) DHCP еnable.
2.4.
To write changes, click
Save.
• If the settings are loaded correctly, a table, containing the new printer settings
and a message "
Settings saved successfully!" are appeared on the screen.
• If an error is occured when loading settings, the changes are not saved and
an Syntax error message is displayed on the screen:
Settings not saved! Check syntax error!
Remove the error and save again.
2.5.
If you wish to return the current network settings of the printer,
click RELOAD.