Dascom 7010 WLAN Installation Guide - Manual (Page 3)

– 4 –
2. Remove the connecting cable from the interface board and reconnect the
cable to the connector of the new interface board.
3. Insert the interface board into the printer so that the connecting cable does
not catch on the printer. The new board is slightly larger than the original
board, so the interface cable will need to be tucked in carefully.
4. Use the two screws that you removed to re-fix the bracket in place.
LAN interface board
Interface cable
Back of printer
Screws
interface board
7106 7206
7010
Attention:
Please insert the Ethernet
board by bending the
cable as shown in the
picture.
- 3 -