Dascom 7010 WLAN Installation Guide - Manual (Page 2)

– 3 –
Installation Guide EN
Replacing the Interface Board
1. Remove the two screws that fix the bracket of the parallel interface board
to the printer. Then gently pull the interface board towards you. When
you do this, be careful not catch or damage the connecting cable. Do not
pull the cable too much as this could also cause damage.
Always turn off the power to the printer and remove
the power cord before replacing the interface board.
Caution
Back of the printer
Interface board
Flat interface cable
Screws
This guide explains how to install the Ethernet LAN card in your label printer.
You should conult your dealer or distributor for more information if you are not
completely sure of how to perform this operation.
This guide explains how to install and configurate the WLAN card 043942 in your
label printer.
- 2 -