Danuser LM40 Hammer - Manual (Page 10)

10
Assembly &
Installation
(continued)
STEP 9:
STEP 10:
STEP 11:
STEP 12:
Grease the grease zerk on the tilt pivot boss.
Route the wires along the hydraulic hoses to the vehicle, and secure them with
zip-ties.
Route the control portion of the wiring harness along the loader arm of the vehicle
and into the cab, and secure the wiring with zip-ties. Mount the switch out of the
way of other controls.
Connect the remainder of the wiring harness to a 12 volt power supply. If
necessary, consult your dealer.
Keep wiring a safe distance from hot components such as a heater or exhaust.
Tilt Option
If the Hammer is equipped with Tilt, follow the instructions below.
Never check pressurized system for leaks with your bare
hand. Wear proper hand and eye protection and use wood
or cardboard when searching for suspected leaks. Oil
escaping from pinhole leaks under pressure can penetrate
skin and create a serious medical emergency. If any fluid
is injected into the skin, gangrene, blood poisoning, even
death may result. Obtain medical attention immediately.
Check the hydraulic system for leaks. STEP 8: