Daisy AVANTI Triumph 747 - Manual (Page 3)

3
OPERATION STEPS
Step 1. Put “ON SAFE” Step 5. CLOSE BOLT
Step 2. OPEN BOLT Step 6. AIM
Step 3. PUMP Step 7. Take “OFF SAFE”
Step 4. LOAD Step 8. FIRE
Step 1. Put “ON SAFE”
Push trigger safety from left to right until no red is showing. In this position, the pistol in
proper working condition cannot be fired by pulling the trigger.
Step 2. OPEN BOLT
Lift up and pull straight back on the bolt
handle. The gun cannot fire with the bolt
open. NOTE: BOLT MUST BE OPEN TO
PUMP-UP GUN.
Step 3. PUMP
With the bolt open, pump gun only once.
Any additional pumping will not increase
velocity. Be careful to keep fingers out of
pumping mechanism when closing the
pump lever. (See PINCH POINTS in Fig. 2)
WARNING: After gun has been
pumped up one, do not attempt to pump
again or open pump lever as the lever
is under pressure and could fly open,
possibly causing injury.
Step 4. LOAD
With the bolt open, load one pellet (solid
end forward) into the feed track. (Fig. 3)
Step 5. CLOSE BOLT
Push the bolt fully forward, then push
bolt handle down. The gun is now ready
to fire.
CAUTION: It is very important that the
bolt be completely closed. Never close
the bolt while the trigger is being pulled.
If the gun does not fire when the trigger is
pulled, open the bolt by pulling the bolt handle all the way back and put “ON SAFE”
immediately, then close the bolt completely and continue to Step 6.
Step 6. AIM
Point gun toward target. Pick a target backstop that cannot be penetrated. (Take final
sighting after Step 7, - See Fig. 4 for correct sight picture).
FIG. 2
PUMP LEVER
BARREL
PINCH
POINTS
When pumping, pull lever as far for-
ward as possible, then with curved
end of lever in open palm, close
lever in fast continuous motion.
Trigger finger should be extended
against the right side of the gun to
react against lever closing force.
FIG. 3
BOLT HANDLE
BOLT TIP