Condux Power Dart Blower 220 VAC - Manual (Page 7)

Troubleshooting Guide
Problem Possible Causes
Missile does not exit at destination • Duct is obstructed
• Duct is not airtight
• Duct length is too long
• Missile is worn or the wrong size
• Too much tension on blowline
• Too many bends in the conduit
Blowline builds up in duct • Drag plate is not properly set
• Missile is worn or the wrong size
Unit does not turn on • Blown utility fuse—not rated for 12 amperes
• Blown fuse in Power Dart Blower
• Bad electrical connection
Replacement Parts List
Part Description Part Number
Outlet Fitting 08039302
Plastic Handle 08066700
Power Switch 02230600
2.1m Power Cord (2.5mm, 3 Con.) 00181800
Fuse, (250V, 7 Amp) 02262200
Label Kit 08065226
Air Hose Seal-Off
Rear Air Outlet
Air Inlet
Power Switches
Blowline
Line Missile
Access Hole
Drag Plate