Condux Power Dart Blower 220 VAC - Manual (Page 4)

IMPORTANT SAFETY INSTRUCTIONS
Outdoor Use Extension Cords
3. If used outdoors, the extension cord must be marked with the suffix W-A following the
cord type designation (e.g., STJW-A).
4. Use an extension cord with the proper wire size for the length of the cord. An
undersized cord will cause a drop in line voltage, resulting in loss of power and
overheating (See Chart below).
5. Position the cord so that it will be clear of any rotating parts and will not be a trip
hazard to the operator.
Don't Abuse Electrical Cord
6. Never lift or carry the Power Dart Blower by the cord, and never yank the cord to
disconnect it from the receptacle. Keep the cord away from heat, oil, and sharp edges.
7. Do not use the Power Dart Blower if a switch is malfunctioning. Have it replaced by an
authorized service center.
Disconnect Tools
8. Always disconnect the power when not in use and before installing, removing, or
servicing the Power Dart Blower.
Keep Work Area Clean
9. Cluttered areas invite injuries.
Consider Work Area Environment
10. Do not use the Power Dart Blower in wet or damp locations, and do not expose
it to rain.
11. Keep the work area well-lit.
12. Do not use the Power Dart Blower in the presence of flammable liquids or gases.
Guard Against Electric Shock
13. Guard against shock, while operating the Power Dart Blower, by preventing bodily
contact with grounded surfaces (e.g., metal pipes).
SAVE THESE INSTRUCTIONS