Comelit MT 3451 - Manual (Page 20)

20
M_
OK
ESC CANC
M_
OK
ESC CANC
PASS KEY
OK
ESC CANC
ENTER NEW CODE
DEFAULT SETTINGS
OK OK
SCROLL ESC
NEW SUPERCODE:
724584
OK
ESC CANC
TYPE OF DOWNLOAD
*OFF
USB
RS485
OK OK
SCROLL ESC
EN
4. Press to start searching.
5. Scroll using and/or press or to confi rm the
selected name.
1.3. Digital keys
1.3.1 ENTER KEY
1.3.2 CHANGE KEY
1. Access programming mode, see page 17.
2. Select data management/keys/(enter/change) by scrolling
through the menu using and pressing or to
confi rm.
3. Enter the name for which you wish to assign/change the key
(in full or just the fi rst letter).
ONLY WITH "ACCESS CONTROL" ENABLED (see section 2.6)
The use of RFID keys can only be managed when "access
control" mode is enabled
1. Access programming mode, see page 17.
2. Select data management/keys/clear all by scrolling through
the menu using and pressing or to confi rm.
3. Press to confi rm deletion or press to exit.
4. Press to start searching.
5. Scroll using and/or press or to confi rm the
selected name.
6. Press to delete the key or press to exit.
1. Access programming mode, see page 17.
2. Select data management/keys/delete by scrolling through
the menu using and pressing or to confi rm.
3. Enter the name for which you wish to delete the key (in full
or just the fi rst letter).
» The confi rmation message "KEY DETECTED COLOUR ..."
will appear on the display.
» The red and green LEDs fl ash alternately to indicate that the
device is waiting for a key to be registered.
6. Move the key over the RFID sensor.
The supercode (default 778899) is used to access the
programming menus.
1. Access programming mode, see page 17.
2. Select the menu entries: Select data management/supercode/
enter new code by scrolling through the menu using and
pressing or to confi rm.
1. Access programming mode, see page 17.
2. Select data management/supercode/default settings by scrolling
through the menu using and pressing or to confi rm.
3. Change the supercode (max. 6 digits).
4. Press to confi rm.
The supercode must be at least 4 digits long
The command cannot be cancelled
For downloading in RS485 mode, see diagram on page 80
1. Access programming mode, see page 17.
2. Select: settings/type of download.
2. Choose between:
OFF
USB
RS485
2.2.1.1 ENTER AUDIO TIME
RANGE = 10 - 180 sec.
1. Access programming mode, see page 17.
2. Select:
settings/system parameters/speaker
parameters/audio time.
3. Enter the desired value:
1.3.3 DELETE KEY
1.2.3 CLEAR ALL KEYS
1.4. Supercode
1.4.1 ENTER NEW CODE
1.4.1 DEFAULT SETTINGS
2. Settings
2.1. Type of download
2.2. System parameters
2.2.1 SPEAKER PARAMETERS