Carter-Hoffmann HL10-10-RW - Manual (Page 16)

16
DAILY CLEANING PROCEDURES—DRAWER WARMER
PRECAUTIONS: Turn control knob to OFF.
Allow
drawers to cool before proceeding.
Remove drawer pans.
FREQUENCY: Minimum—Daily
TOOLS: Warm water and mild detergent
Clean cloth or sponge
1. Remove drawers from warmer:
A. Pull warmer drawer out until fully extended
B. Slide finger along left and right slide rail until you reach the
latches (located at the front end of the cabinet-mounted
rails). Press down on both left and right latch.
C. Pull drawer away from warmer.
CAUTION:
ELECTRIC SHOCK
HAZARD
Disconnect appliance from
electric power before cleaning.
CAUTION:
HOT SURFACE
Exposed surfaces can be hot
to the touch and may cause
burns. Allow appliance to cool
before cleaning.
IMPORTANT:
DO NOT spill or pour water
into controls, control panel or
wiring.
Water damage is not covered
by warranty.
CAUTION:
Beware of sharp edges with
sheet metal during cleaning
process.
2. Clean drawers, drawer pans, Humitrol racks and/or insets with
warm water and mild detergent.
Rinse all components thoroughly with clear water.
Dry all components prior to reinstalling them in warmer.
3. Sweep crumbs and other debris from warmer cavity.
4. Clean the outside of the unit by wiping with a clean cloth or
sponge, warm water and mild detergent. Dry with a clean
cloth, then wipe with a polish formulated for stainless steel.
5. It is important to keep the slide rails clear and free of debris.
Periodic cleaning of the slide rails and other adjoining parts is
necessary to assure smooth drawer operation.
6. Check drawer rollers. Be sure they roll freely and that the slide
rails are free from debris.
7. Be sure cabinet-mounted drawer catch roller is “up”, then
reinstall drawers.