Installation – Caron 6105 User Manual
Page 8
Model 6105 Operations Manual Rev I
03/03/2014
Page 8 of 22
INSTALLATION
Unpacking
This product has been completely tested, cleaned and packed for shipment. Carefully remove all packing
material. Please examine the chamber completely. Should any damage be found, notify the delivering
carrier immediately. Report any shortages to your local distributor or contact CARON customer service at
740-373-6809, 800-648-3042 (USA only) or [email protected].
Caron provides full on-site installation services for all models. Our installation
services guarantees the proper set-up and startup of all equipment. Please contact
the Service Department at 740-373-6809 or
Chamber Location
The chamber must be located in a dry, clean, and level area. Allow a 2 inch (51 mm) clearance from the
back of chamber for proper air circulation. Locate the chamber in an area out of direct sunlight and away
from heating and cooling ducts.
Caution: Do not put more than 5 lbs (2.3kg) on top of unit.
The figure below shows the exhaust port on the back of the chamber. Install rubber stopper/vent into port
and press in firmly. Make sure vent is in upward position as shown. If external ducting to a fume hood or
exterior vent is necessary, make connection here. Note that temperature, humidity, and recovery time will be
affected.