Carbolite 301 - Manual (Page 14)

Ramp Dwell Programming
14 MC16-GB-C – 1.04
Set the Temperature setpoint.
Start at the Home display
Press the Page key until
SP%C shows on the display
Use the Up and Down arrow keys to alter the value (°C)
The value will then be stored without any further input.
Set the Setpoint ramp rate
Press the Page key until
SPrr shows on the display.
Use the Up and Down arrow keys to switch off or alter the value (°C/min)
The value will then be stored without any further input.
Set the Dwell time
Press the Page key until
T1 shows on the display.
Use the Up and Down arrow keys either to switch off or alter the value (Hr:Min)
The value will then be stored without any further input.
Start the Timer
Start at the Home Display
Press the timer key to start the program.
Pressing the timer key will also automatically exit hold mode if set (see section 2.5)
and the controller will start to run.
SP%C
SPrr
T1