CalDigit VR - Manual (Page 5)

5
A. Installing the CalDigit VR
The CalDigit VR is ready to use out of the box.
1. Select the desired interface, FireWire 400, FireWire 800, USB
2.0 or eSATA. A FireWire 800 and eSATA cable are included.
2. Connect the power supply to the CalDigit VR, then connect
the desired interface cable.
Note: If you would like to use eSATA, there are two
options. If you already have an eSATA controller
card or port simply connect the eSATA cable. If you
have a Mac or PC workstation that has internal SATA
port (late model Mac Pros) you can use the included
eSATA extender*. For installation instructions please
refer to the CalDigit eSATA Extender manual. If your
workstation does not have an internal SATA port and
you would like to use eSATA with the CalDigit VR
you can purchase one of CalDigit's eSATA controller
cards (FASTA-1ex, FASTA-2e or FASTA-4e). For more
information visit www.caldigit.com.