C.B.S. Scientific SG Series - Manual (Page 7)

C.B.S.  Scientific 7 Adjustable Height Sequencer
Section 2
Description of Parts
2.1 Unpacking- Adjustable Height Sequencer
Please verify that your sequencing unit comes complete with the following components:
• Buffer reservoirs, upper & lower with • Leveling base with leveling feet
safety covers with attached power leads
Drain plugs installed in upper reservoir • Guide Rods
• 6 white spring clamps • 2 white nylon tubing adapters for buffer
(Cat.# GPC-0001) drain ports
• 2 knurled black thumb screws • Rosette knobs (three)
for securing lower reservoir to base
reservoirs
If a kit was ordered verify that you received the following accessories:
• 1 comb (sharktooth or rectangular) • 1 set spacers
• 1 set glass plates • 1 roll gel sealing tape, Cat. # GT-72-10
• 2 wedge plate separators • 1 temperature strip, Cat.# EGT-100 (not shown)
Cat. # WPS-100 (not shown)