Bos VIP'R 2.1 2014 User manual User Manual

Page 7

Procedure

CAUTION

Make sure that the Oring or the grease do not obstruct the air holes. (picture 6).

1. Install the shock in a vice using the soft
jaws(picture 1).

2.Tighten slightly to avoid damaging your shock.

3.Take note of the current pressure in your
shock before deflating it. Take into account the
air loss, due to the insertion of the pump.
Completely deflate the shock.

4. Unscrew the air can (b), by firmly handling the
shock body (a) (picture 2).

5. Remove the air can (picture 3).

6. Add the O'ring by the shaft side (pictures 4 &
5) and drag them to their position (picture 6)

7. Make sure that the rebound knob and the
sticker of the shock body (a) are aligned.

8. Place the air can to the shock body and screw
it until the alignment of the stickers is correct.
(picture 7)

9. Inflate the air chamber.

10. Install the shock on the bike.

11. Proceed to the air chambers balance
(chapter 3.2).

Make sure that the jaws are applied on a flat
surface and do not touch the rebound knob
nore the compression lever.

The shock body must not be unscrewed. The
air can must be unscrewed by hands only
(no tool)

CAUTION