Settings, Introduction, Assembly – Bos VIP'R 2.1 2014 User manual User Manual
Page 3
Thank you for purchasing a Bos Vip'R2 shock. Your shock has been assembled specifically for one bike - obviously
yours ! - which means that the internal valving and the air chamber volume are settled for your bike. The adequate
mounting kit is also provided with the shock.
Your VIP'R2 shock features adequate mounting kits for the bike mentionned while ordering.
Check the mounting way
by refering to the compatibility table, available on bos mtb website :
Refer to the bike manual
to follow the specific shock mounting procedures of your bike.
3.1. AIR PRESSURE
Before using the shock, you must set up the air pressure, depending on your weight.
The air pressure is not related only to your weight but also to your bike’s rear suspension geometry.
Refer to the compatibility table on Bos mtb’s website, in the download area :
http://www.bosmtb.com to check the correct air pressure, related to your weight AND your bike..
Connect a pump equipped with a precise manometer to the Schrader valve located on the side of the upper part of
the body, and inflate at the right pressure.
3. SETTINGS
1. INTRODUCTION
CAUTION
Never try to disassemble your shock. Limit yourself to the instructions given in this manual.
This shock is pressurized, for your own safety, do not try to open it.
Contact an authorized service center for any maintenance operation.
2. ASSEMBLY
air valve