Cam adjustments – Bear Archery Compound Bow 2012 User Manual
Page 20

20
CAM ADJUSTMENTS
Adjusting Draw Length – Perimeter
Weighted Modular Single Cam (1” size
module draw length adjustment)
Bow model:
• Mauler
• Attack
• Assault
The perimeter weighted single cam has a modular
draw length adjustment. Most draw length
adjustments can be made without the use of a
bow press. Draw length changes are made by
simply changing modules and moving the draw
stop. Accessory modules are available from your
local Bear Archery dealer in one-inch draw length
increments. Each module is numbered, with #10
being the longest draw length and #5 being the
shortest. To change modules remove the socket
head cap screws from the present module,
remove that module and replace with a new
module. Such module draw length adjustments
will not affect peak draw weight.
Modules are
right and left hand specific.
USE ONLY RH
MODULES ON RIGHT HAND CAMS AND LH
MODULES ON LH CAMS!
When a module is
changed, the draw stop must also be moved to
the corresponding setting marked on the cam.
Additionally, fine draw length adjustments of ½
inch can be made by removing the bowstring
from the standard “dot” string post and
reattaching it to either the “+” or “-“ string posts
on the cam. Moving the string to the “+” post
will increase draw length by ½” and moving the
string to the “-“ post will decrease draw length by
½”. To make such adjustments, it is first
necessary to remove tension from the harness
system of the bow by compressing the bow in a
bow press.
A fixed or portable bow press must
be used! Under NO circumstances can this
relaxing of the harness system be
accomplished by simply backing out limb
bolts. Refer to the images on the next page for
additional reference.