Setting the two sided draw stop – Bear Archery Compound Bow 2012 User Manual
Page 15

15
Setting the TWO SIDED DRAW
STOP
When a module is changed, the draw stop must
also be moved to the corresponding setting
marked on the cam. The Anarchy has a new two
sided draw stop system. This system consists of
a draw stop that utilizes two mounting bosses to
achieve different draw stop settings. Each draw
stop is marked with a 1 on one side and a ½ on
the other side. These marks are used to match
the stop with the desired module. If a whole
number module is to be used, the draw stop
must have the 1 facing out when mounted, if a
half number module is to be used, the draw stop
must have the ½ facing out when mounted.
There is only one mounting hole in the cam for
each whole and half number module set. For
example, when setting a bow up with either a
number 6 or a number 6 ½ module, the stop will
mount in the #6 hole for both settings, but on
the 6 module, the stop will read “1” facing out,
and on the 6 ½ module, the stop will read “1/2”
facing out. The stop will only mount in one
orientation for each setting. DO NOT force the
stop into the mounting hole; it will slip into the
hole when the correct orientation is achieved.
Example Shown:
Refer to the images on the next page for
additional reference.