BASELINE Robo-Assist Accessory Kit 85607617 - Manual (Page 4)

4 • Tire Changers
11. Grease the steel ball and place it in the bottom
of the assist tool.
Figure 11 - Place greased ball in bottom of assist tool.
12. Next, install the assist tool onto the cylinder shaft
using the roll pin.
Figure 12 - Install assist tool onto cylinder shaft.
13. Connect 1/8-inch nylon tubes from robo cylinder
to cylinder arm valve fittings, as shown in figure 13.
Attach cable tie around tubes to bottom cylinder fitting.
Figure 13 - Connect nylon tubes.
14. Attach hose clamps to arms. Next, unwrap the
hose from valve, guide through hose clamps; and, with
the hose pushed over the barbed fitting, tighten hose
clamps by pulling clamp tabs off.
Figure 14 - Route hose and tighten hose clamps.
15. Next, reconnect the air pressure source and
check for leaks. Cycle the cylinder on the Robo-Assist™
several times to make sure cylinder operates correctly
(valve up for cylinder up - valve down for cylinder down).
Roll Pin
Use Cable
Tie To Nest
Tubing
Route and
Connect Hose
Nylon
Tube
Nylon
Tube
A
A
B
B
C
C