Barranca Diamond 6-inch TS6 Trim Saw - Manual (Page 9)

Shipping Weight 40 lbs.
Main Motor Baldor
Horsepower 1/3 HP
Motor Voltage 110 volt / 60 Hz / Single phase
Motor RPM 1725 RPM Fixed
Shaft 5/8"
Blade Capacity 6" (152.4 mm) diameter
Vise Capacity (optional) 1.75" (44 mm) Part# 8300015
Part#
8300017
TS6
The TS6 will manually cut specimens up to 1-1/2" (30mm) in height and has a 10" (254 mm) x 11" (279
mm) self-aligning tabletop.
Blade Lubricate
Approximately 1.4 liters (.37 gallon) of lubricant is required to adequately cover the bottom of a 6-inch
(152.4 mm) blade. See Figure 6 for proper lubricant level.
The use of petroleum or vegetable based mineral is highly recommended as a lubricant for use with
TS6.
NOTICE
CAUTION
Water is not recommended for use with the Saw. The steel arbor shaft can rust. In addition,
poor sawing performance and short blade life can result if water is used.
Personal injury. Use diamond blades only. Do not use abrasive blades. Particles break away from
abrasive blades and may cause personal injury.
UNPACKING
The TS6 6-inch Trim Saw has been carefully packaged for protection during transit from the factory to
your location. The blade has been factory installed and the arbor nut securely tightened. No assembly
is required.
Carefully unpack and check that the following items have been received:
• (1) Ground Fault Circuit Interrupter (GFCI)
• (1) Dressing Stick
• (4) Rubber Feet and Mounting Screws
If any components are missing or damaged, save the packing list and materials and advise Barranca
Diamond and the carrier of any discrepancies.
Trim Saw Packaging Components
TS6 SPECIFICATIONS