Barranca Diamond 6-inch TS6 Trim Saw - Manual (Page 12)

1
Power Switch
A Ground Fault Circuit Interrupter (GFCI) is included with the TS6.
1. Check that the power switch is in the OFF position.
2. Attach the power cord from the power box to the GFCI. Plug the GFCI into a 120V / 60Hz / 15
amp (minimum) power receptacle (see Figure 9).
3. Push the GFCI RESET button on the switch. A red light will appear to indicate the switch is
energized.
• If the TEST button is pushed, the GFCI will click off and de-energize itself indicating the GFCI
is functioning correctly.
Figure 9: GFCI Between Outlet and Power Cord
Power Test
1. Move the power switch to the ON position to rotate the blade (see Figure 10).
2. Check that the blade is rotating. This indicates the saw is functioning properly.
3. Move the power switch to the OFF position.
Figure 10: ON / OFF Switch
TS6 POWER SWITCH