Bunn POWDER AUTO FILL - Manual (Page 17)

17
SERVICE (cont.)
when reconnecting wires.
13. Slide the slinger onto the motor shaft flush against
the front panel.
14. Wash whipper chamber components in a mild
solution of dish detergent using a bristle brush.
15. Rinse thoroughly and allow to dry before reinstall-
ing in the dispenser.
16. Slide whipper chamber receptacle with seal and O-
ring onto the motor shaft.
17. Rotate the receptacle with seal counterclockwise
until it snaps into place on the motor mounting
nuts.
18. Push frother onto the motor shaft, making sure the
flat in the frother lines up with the flat on the motor
shaft.
19. Connect the red/black and green wires to the hop-
per switch, Fig.10 and install the hopper support
panel using the four #8-32 screws.
20. Install whipper chamber on the whipper chamber
receptacle by twisting counterclockwise until tabs
on the whipper chamber lock with the tabs on the
whipper chamber receptacle. Be sure dispense port
is pointing down.
WHIPPER MOTOR (cont.)
FIG. 9 WHIPPER MOTOR TERMINALS
P1903
FIG. 10 HOPPER SWITCH TERMINALS
P1904
21. Install dispense tip into the bottom of the whipper
chamber.
22. Slip the mixing chamber onto the mixing chamber
water inlet tube far enough so the mixing chamber
will seat inside the whipper chamber.
23. Install hopper assembly in the dispenser by sliding
hopper assembly on the hopper support panel until
the slot in the bottom rear of the hopper seats
against the pin and retainer plates on the hopper
support panel.
WHI/RED to Control Board (J7-2)
WHI/BRN to Control Board (J7-4)
BLK
GRN to Control Boad (J1-8)
RED/BLK to Control Board (J1-10)
29793 061599