Bakers Pride 616 Manual - Manual (Page 19)

19
GAS CONVERSION
There are times it is required to do a field conversion from one gas type to another.
Consult with your Technical Service Representative to order the correct parts for the oven model you
will be converting.
♦ Shut off the gas to the oven.
♦ Remove the two screws that hold the regulator in place on the combination valve. Remove the gas-
ket. Install a new gasket and the new regulator. Insure the regulator gasket is in place with two
circular cut-outs over small posts in the valve body casting. Evenly tighten the two screws holding
the regulator in place. The conversion kit includes a label to be placed on the side of the valve
body to inform others that the conversion has taken place.
♦ Remove the orifices from the inspirators. Depending on the oven model there will be one, two or
three that need to be changed.
♦ Change the orifice in the pilot.
♦ Refer to other sections of this manual. Test for gas leaks.
♦ Follow normal start-up procedures for lighting and adjusting the pilot and insuring the gas-air mix-
ture to the burners is correct.
WARNING
Conversion kits shall be installed by a quali-
fied service agency in accordance with the
manufacturer's instructions and all applicable
codes and requirements of the authority hav-
ing jurisdiction. If the information in these
instructions is not followed exactly, a fire, an
explosion or production of carbon monoxide
may result causing property damage, personal
injury or loss of life. The qualified service
agency is responsible for the proper installa-
tion of this kit. The installation is not proper
and complete until the operation of the con-
verted appliance is checked as specified in the
manufacturer’s instructions.
REGULATOR
REGULATOR
GASKET
NOTIFICATION
LABEL
ORIFICE