Autoquip CMD DOCK LIFT - Manual (Page 17)

17
3. Lower the lift until the base frame, at the cylinder end, picks itself off of the floor
approximately one inch.
4. The lift can then be moved by pulling or pushing on the “T” handle.
To disengage the portability set:
1. Lift the “T” handle to a vertical position and remove it from under the tang. Be
careful, as the handle will have a tendency to pull away as the base is lowered to the
floor.
2. Raise the lift approximately half way and rotate the portability wheels on the platform
to their raised and stored position. The lift can then be operated in a normal
manner.
NOTE: The lift must not be used for loading or unloading with the wheels in the
portability position.