Autoquip GATES VERTICAL ACTING - Manual (Page 9)

9
WARNING !
SAFETY PRACTICES
Support all posts and components! Illustrations in this manual may show
them unsupported. This is done in order to make the equipment and its
installation clearly understood. Be sure to properly secure all lift beams
and components on the actual unit!
WARNING !
Never run the unit with the gates or doors open! The gates must not
open when the lift is in operation or when the platform is not present.
Should this condition exist, the interlock circuit is not functioning properly
due to incorrect installation of, or damage to, status switches and/or
interlocking components. This condition must be corrected immediately.
Failure to correct this condition may result in serious injury or death.
WARNING !
Never operate unit when parts are defective! Do not operate this
equipment when substandard or defective parts are in use! Contact an
Autoquip Service Representative to rectify all such situations.
CAUTION!
Do not run powered gate until limit switches are set! If the electrical
work is not complete, do not run the gate to full up or full down positions
until the limits are set.
CAUTION!
Cables must be seated before raising gate! Be sure the cables are
seated in the overhead pulleys prior to raising the gate.