Anchor LIGHT EXPEDITIONARY SHELTER - Manual (Page 9)

9
STEP 5 - Position and stake the base
plates.
• Position one end base plate 21’-9” from the other
end base plate. Measurement is from outside edge
of plate to outside edge of plate. See figure 5a.
• Then measure from this base plate diagonally to
the opposite base plate. Measurement should be
31’-2” from inside corner to inside corner. See fig-
ure 5a.
• Lightly stake the plates in position.
• Position the other end base plate 25’-10” from its
corresponding mate and lightly stake in place.
• Align the mid base plate between the two ends
but do not stake in place. Stake only after
ground bars and J bolts are inserted into mids
and base plates. (See Steps 9 to 10)
• Check and adjust until the diagonal measure-
ments are equal.
Figure 5a
LES Standard Base Frame
Figure 6a
LES - 8’ Extension Kit
Figure 6b
LES - 16’ Extension Kit
Aligned Base Plates
Aligned Base Plates
Note: For installation of frames with extension kits, use figures 6a and 6b for measurements.