Brother 885-X06 - Manual (Page 42)

USING ATTACHMENTS AND APPLICATIONS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
41
Using the quilting guide
Use the quilting guide to sew parallel stitches that are
equally spaced.
1
Insert the stem of the quilting guide into
the hole at the rear of the walking foot or
presser foot holder.
■ Walking foot
■ Presser foot holder
2
Adjust the stem of the quilting guide so
that the quilting guide aligns with the
seam that has already been sewn.
Using the quilting foot
The Quilting Foot is useful for darning and
free-motion machine quilting.
1
Follow the steps
1
to
3
on page 40.
2
Attach the quilting foot, making sure that
part A shown in the illustration is above
the needle clamp screw. Then lower the
presser foot lever and tighten the presser
foot screw.
• Make sure that the needle clamp screw is
firmly tightened.
1 Presser foot screw
2 Needle clamp screw
CAUTION
3
Put the darning plate on the needle plate.
Turn on the machine.
4
Set the pattern selection dial to the
Straight Stitch.
• Before starting to sew, draw the quilting
design on the fabric.
Stitch
Name
Pattern
Stitch
Length
[mm (inch)]
Stitch Width
[mm (inch)]
Other
Straight
Stitch
Any
2.5
(3/32)
Darning
Plate
2
● Use the oval screwdriver to tighten the
presser foot holder screw securely. If the
screw is loose, the needle may hit the
presser foot and you may be injured.
● Turn the handwheel toward you
(counterclockwise) and check that the
needle does not touch the presser foot. If
the needle hits the presser foot, the
needle may bend or break.
A
1
2