Anchor FIESTA FRAME TENT LIFT User Manual

Page 2

ANCHOR INDUSTRIES INC

FIESTA FRAME LIFT

ASSEMBLY, USE & MAINTENANCE

B. PART LIST:

The Fiesta Frame Lift is shipped in (2) containers as follows:

(1) Carton, Approximately 6” x 5” x81” containing:

(1) Upright 2-piece pole assembly with base bolt, web guide bolt, and winch

housing bolts (2) pre-installed.

(1) Cardboard Box, Approximately 28” x 11” x 37 1/2” containing:

(1) Base plate with wheels.

(1) 9” x 9” x 21” carton containing (1) winch (assembled with web, web guide, and

eave hook), winch handle, bushing bolt & spring, & flat washer.

C. ASSEMBLY:

Remove base bolt from base socket. Insert bottom pole section into base socket.

Replace base bolt and nut and tighten.

Remove Top Pole Section from storage rings and lay aside for now.

Remove winch housing bolts, nuts, & washers from upper end of bottom pole section.

Position winch at backside of bottom pole section with handle shaft to the right side

as viewed from behind (near the base wheels). Secure the winch by reinstalling the

winch housing bolts through the winch housing and then into the pole. See front cover

illustration for direction. Use a 5/8” open-end wrench inside the winch housing and a

9/16” ratcheted socket on the bolt heads on the outside of the pole to tighten.

Slip bushing over the threaded shaft of the winch. Slip retainer spring over bushing.

Attach winch handle with bolt & flat washer provided.

Remove web guide bolt and install web guide into upper end of top pole section.

Replace guide bolt and tighten.

Lay lift on side and slide top pole section over the male splice at the upper end of the

bottom pole section.

Raise lift upright and rotate top pole section until hook is toward the eave bar of the

tent to be lifted. CAUTION: Be sure web is not twisted nor wrapped around pole.

TOOLS NEEDED FOR ASSEMBLY:

(1) 3/4” Open End Wrench (Note: Anchor’s Fiesta Wrench has both a
(1) 5/8” Open End Wrench 3/4” end and a 5/8” end.)
(1) 1/2” Open End Wrench
(1) Ratchet Wrench with 9/16” Socket