Altman Lighting Phoenix Series Ellipsoidal Spotlight - Manual (Page 4)

Altman Lighting, Inc. 57 Alexander St., Yonkers NY, 10701 1-800-4-ALTMAN
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. COPYRIGHT 2012© ALTMAN LIGHTING, INC. ALL RIGHTS RESERVED.
INSTALLING SHUTTER PLATES
1. Pressure Plate (completely fl at): Install such that the tabs are
on the top and bottom and sides.
2. Iris and spring plate. Install so that the (4) studs face the
back of the unit.
SHUTTERS
1. 5IFTIVUUFSTBSFOPUSFNPWBCMFXJUIPVUEJTTFNCMJOHUIFVOJU
2. $BSFNVTUCFHJWFOUPNBLFTVSFFBDIPGUIFGPVSTIVUUFSTTUBZ
JOUIFJSQSPQFSQPTJUJPOTJOCFUXFFOUIFTIVUUFSQMBUFT
CLEANING/REPLACING LENSES
1. Remove focus lock knob, push in safety pin and slide lens
barrel out.
2. Place barrel on a surface so that the two halves are oriented
as the top and bottom.
3. Remove lower accessory cover with (2) screws.
4. Remove top latch cover with (2) screws.
5. Remove (4 ) barrel screws, one on each side.
6. Carefully remove top half of the barrel.
7. Replace or clean lenses with mild soap and water, and a
clean, lint-free cloth.
8. Replace top half of barrel, top latch cover, bottom cover and
re-install screws.
9. Slide lens barrel back into unit and replace focus lock knobs.
WARNING: Never use glass or window cleaner or any abrasive material to clean
a lens. These types of cleaners will stain the lens surface. Abrasive materials will
damage the surface of the lens.
50° (4.5 X 6) 36° (6 X 9) 26° (6 X 12) 19° (6 X 16)
Top latch cover
Barrel screws
Lens retainer
rings
Lower accessory
cover
Lens
Shutter
Plates
Plate
Studs
Plate
Stud
Springs