Altman Lighting Phoenix LED Profile Spot - Manual (Page 8)

Altman Lighting, Inc. 57 Alexander Street., Yonkers, NY 10701 1-800-4-ALTMAN
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. COPYRIGHT 2012© ALTMAN LIGHTING, INC/ ALL RIGHTS RESERVED
1/24/14 rev:C
8
Operation Menu and Options
There is a player option in the menu where you can pre-program your fixture to play back up to 5
cues. The cues can run as short as 1 second or as long as 99 minutes. You can choose any of
the colors you desire within your cues to create any look you want. You also have the option of
putting a delay in between your cues. To program your cues follow the steps below.
Press ENTER to turn the screen on.
Press DOWN to get to the “player” option.
Press ENTER to capture the “player setting”.
Press DOWN to turn the player one or off. In this case we will be turning the player on.
Press MENU once to back out of “on/off” selection.
Press DOWN to go to “Edit Presets”.
Press ENTER to go to “Edit Cue 1”.
Press UP or DOWN to select cue # you would like to edit. In this case we will start with
cue 1.
Press ENTER to select “Cue 1”.
Press Enter to select if you want to enable the Cue on or off. Select “enable”.
Press MENU to back up one step.
Select the channel/color you desire for your first cue. For example select red press
ENTER.
Press UP and scroll to “255” for full intensity.
Press ENTER to confirm.
Press MENU to back out of red selection.
(Repeat these same steps to edit the rest of your cues.)
Menu Category Control Type Option 1 Option 2 Option 3 Factory Default
Player On PLAYER Off
On
Cue # 1
OR
Cue #2
OR
Cue #3
OR
Cue#4
OR
Cue # 5 Enable/Disable
Delay
Red
Green
Blue
White
Off / On
1 sec to 99 min
0 to 255
0 to 255
0 to 255
0 to 255
On
On
2.0 seconds
255
0
0
0
Spreadsheet for Menu categories for the player