Allen&Heath XB-10 - Manual (Page 24)

Allen & Heath 24 XB-10 User Guide
OUTPUT SELECTOR
PGM
CLF-TELCO
PRO
AUX-ALT
AUX
MASTER
+6
L R
0
MAX
RECORD OUT
SOURCE
AUX-MONO
MAIN
PGM
L R
LEVE
MIN
GU
ES
T
USB OUT SOURCE
The signal source for the USB send is selected using the switches below
the USB connector.
If both switches are un-pressed, the pre level main program mix will be
sent to the USB output, if the AUX-ALT button is pressed then the AUX
and ALT mixes will be sent to the left and right channels respectively. If
the CLF-TELCO button is pressed then then left channel will send the
telco channel cleanfeed and the right channel will send the TELCO chan-
nel signal.
The CLF-TELCO feed is primarily for use with a VOIP program such as
SKYPE. The left channel is used by SKYPE to send a cleanfeed mix to the
caller. The left and right channels can be recorded using another piece of
software to give a copy of the callers channel and the program cleanfeed
mix.
RECORD OUT SOURCE
The signal source for the RECORD output is selected using these switch-
es .
If both switches are un-pressed, the pre level main program mix will be
sent to the REC OUT phono connectors, if the AUX-MONO button is
pressed then the AUX and MONO mixes will be sent to the left and
right channels respectively. If the CLF-TELCO button is pressed then
then left channel will send the telco channel cleanfeed and the right chan-
nel will send the TELCO channel signal.
AUX MASTER
This controls the amount of signal sent to the AUX OUTPUT RCA phono
socket. The send control varies the signal level from off (fully attenuated)
to +6dB, with unity gain at the arrow.
MONITOR LEVEL
This controls the amount of signal sent to the MON OUT RCA phono
sockets. The send control varies the signal level from MIN (fully attenuat-
ed) to MAX (+10dBu).
MUTE LED / MIC MUTE MONITOR SWITCH
Press the MIC MUTE MONITOR option switch to activate the monitor
speaker muting.
This is used to turn off studio monitor speakers when the MIC channels
are being used to eliminate any feedback paths.
When a MIC channel ON switch is illuminated, the mute LED will come
on and the MON OUT feeds are muted.
The MON OUT feed can also be remotely operated using logic connected
to the rear panel. The mute LED will also come on in this case.