Allen h eath, Mix b out, External monitor input – Allen&Heath XB 14 User Manual
Page 23: Main pgm inserts, Main pgm outputs, Aux output, Mono output, Headphone output sockets
Allen & Heath 23 XB-14 User Guide
L
+16
-6
-9
-20
-30
-16
-12
-3
0VU
+3
+6
+9
R
PFL ACTIVE
MIN
MAX
PHONES
AUX
MIX B
EXT
CRM
SPEAKERS
L
R
48V
INSERT R
MAIN
PHANTOM POWER
ALLEN
H
EATH
AUX
INSERT L
+16
-6
-9
-20
-30
-16
-12
-3
0VU
+3
+6
+9
CUT SPKS
DIM SPKS
TO MICS
PFL ENABLE
TO GUEST
GUEST PHONES 1 GUEST PHONES 2 CRM PHONES
EXT MON IN
L
R
0
5
10
15
20
MIN
MAX
CRM
TALK
TO GUEST
POWER
MIX B OUT
L
R
MIN
MAX
LEVEL
MIX B
PGM MIX
FADER
CRM+PHONES
SELECTION
USB
PHONES
MIN
MAX
GUEST
GUEST PHONES
SELECTION
MIC FADER UP
=CUT SPKS
MONO
OUT
IN
MON
OUT
&
PGM
6
4
5
7
3
MASTER SECTION
MIX B OUT
Standard RCA phono sockets for the MIX B bus output. The output
level can be controlled by the MIX B Level control.
Nominal level = 0dBu, unbalanced.
1
1
2
External Monitor Input
Standard RCA phono sockets for a stereo signal which can be routed
to either the engineers’ CRM monitor headphones & speakers, or the
guest headphones. It can be used for monitoring the program trans-
mission or switching any external stereo source to the engineers or
guests monitors.
Nominal level = 0dBu, unbalanced.
2
Main PGM Inserts
Standard 1/4” (6.25mm) Jack socket for unbalanced insert send and
return signals.
Wired Tip=send, Ring=return, Sleeve=Chassis. Nominal level is 0dBu.
The insert point is pre the main PGM fader.
3
Main PGM Outputs
Standard XLR output connector for the main program mix left &
right outputs.
Wired Pin 1=Chassis, Pin 2=hot (+), Pin 3=Cold (-).
Electronically balanced, nominal level = +4dBu (=0VU).
4
AUX Output
Standard 1/4” (6.25mm) Jack socket for aux output.
Wired Tip=Hot (+), Ring=cold (-), Sleeve=Chassis. Impedance bal-
anced. Nominal level = 0dBu.
5
Mono Output
Standard RCA phono socket for the Mono PGM bus output.
The mono program bus is Nominal level = 0dBu, unbalanced.
The PGM mono output is a mono version of the main PGM stereo
out but is independent of the main fader.
6
Headphone Output Sockets
Standard 1/4” (6.25mm) Jack sockets for the engineer/self operator
and two guests.
Wired Tip=Left (+), Ring=Right (-), Sleeve=Ground.
7
Warning ! To avoid damage to your
hearing do not operate the headphones
or sound system at excessively high
volume. Continued exposure to high
volume sound can cause frequency
selective or wide range hearing loss.
82
!