AirLive WL-5460AP v2 - Manual (Page 58)

AirLive WL-5460AP v2 User Manual
59
Interface Control Settings:
In the Interface Control Settings, the AP only controls the total bandwidth limit of an
interface. For example, if you want to limit the output data rate of the LAN to 512K and the
output data rate of WLAN to 1024K. You should
perform the following steps:
1. Enable the “Interface Traffic Control
2. Enter “512” in the “LAN Output Rate”
3. Enter “1024” in the “WLAN Output Rate”
4. Click on “Save”
5. Reboot the AP.
B. Define Policy
A policy is a set of bandwidth rules that can be used as a template. For example, if you
want to provide 2 kinds of bandwidth
speed to the users:
l VIP Subscriber:
n LAN Out Rate: 512 Kbps
n WLAN Out Rate: 1024 Kbps
l Regular Subscriber:
n LAN Out Rate: 64 Kbps
n WLAN Out Rate: 512 Kbps
You can configure the bandwidth rule as policies “VIP” and “Regular”.
Please follow the step below to create a new policy “VIP”
1. Enter “VIP” for the “PolicyName”
2. Enter “512” for the “LAN Out Rate”