AirLive WHB-5854A User Manual

Page 24

AirLive WHB-5854A Wireless Outdoor Bridge

Picture 15 Auto Get IP

This will get the IP address from DHCP server if you have DHCP server enable in
your subnet.

4.1.3.2.3 Configure 5GHz Bridge Setting

Radio Setting
1) Bridge Type: If the application is only for “Point to Point” architecture, the

set it as Slave one on each side. If the intended configuration is for “Point to
Multipoint” network architecture, you need one bridge loaded with Master
Bridge as host to wireless connect with the multiple remote bridges loaded
with Slave Bridge(s).

2) Remote Bridge MAC Address: In order to establish the wireless link

between bridge radios, the MAC address of remotes bridge(s) need to be
registered in the address table. Type the MAC address with format
xx:xx:xx:xx:xx:xx (x is the hexadecimal digit) and use “Add” and “Delete”
button to edit the address table. A Master Bridge Radio may accommodate
up to 4 remote MAC addresses.

3) Bridge Security Please refer to “Bridge Security Setting” in the next section.
4) Wireless Mode There is two modes provided: 54Mbps (802.11a) and

108Mbps (802.11a Turbo). The mode of 108Mbps offers the double data rate
than of 54Mbps.

5) Channel Select a radio channel according to the availability or system plan.

It is required for Bridges having the same radio frequency to communicate
each other. “SmartSelect” is NOT recommended for the bridge applications.

6) Data Rate Available data rate range is dependent on the selection of Wireless