AirLive POE-FSH808PW User Manual
Page 48
4. Web Management
AirLive POE-FSH808PW User’s Manual
43
The STP Port Setting page allows you to change the port priority and its path cost.
After STP/RSTP is enabled, the system automatically assigns the port priority and path
cost to the prot. Normally, it is necessary to change the parameters, however, you may
need to control the root switch or block port in some condition.
This page allows you to change the STP port setting. Select the port number, type the
value of the Priority and Root Path Cost.
Click
"Submit" to apply the settings.
Port No: The port ID. It cannot be changed. Aggregations mean any configured trunk
group.
Root Path Cost: This parameter is used by the STP to determine the best path
between devices. Therefore, lower values should be assigned to ports attached to
faster media, and higher values assigned to ports with slower media. Set the RSTP
path cost on the port. Number between 0 - 200000000. 0 means auto generated path
cost.
Priority: Show the value of the Port Priority. Ex: 0x80 is 128.
State: Show the current port state includes Designated port, Root port or Blocked
port.