AirLive BU-3025 - Manual (Page 26)

4. Administrating the Device
AirLive BU-3025 Manual 20
Here are the descriptions of every setup item:
z
LAN:
Select this option to assign an IP address to LAN port (or obtain an address from
DHCP server automatically).
Available options are:
- DHCP IPv4: Obtain an IPv4 IP address from DHCP server on LAN automatically.
- DHCP IPv4 / IPv6: Obtain both IPv4 and IPv6 address from DHCP server on LAN
automatically.
- Static IPv4 / IPv6: Assign an IPv4 / IPv6 address to IP camera manually. If you
don’t have a DHCP server on your local area network, you must use this option to
specify an IP address.
- IP Address (IPv4): Input IPv4 IP address*
- IP Address (IPv6): Input IPv6 IP address*
- Prefix Length: Input IPv6 IP address’ prefix length (0‐128)
- Subnet Mask: Input subnet mask
- Gateway: Input gateway address
- Primary DNS: Input DNS server’s IP address
- Secondary DNS: Input backup DNS server’s IP address, you can leave this field
blank.
* You can leave this field blank, if you only wish to use IPv4 or IPv6 IP address.
Enable UPnP Discovery: Check this box to enable other devices on network to
discover the presence of this IP camera by UPnP. It’s recommended to enable this
function.
Enable UPnP Port Mapping: When UPnP is enabled, check this box to enable UPnP’s
port mapping.
z
PPPoE:
Select this option to use PPPoE to connect to network. You have to input PPPoE
username and password assigned by network operator to get connected.
z
HTTP Port:
Input IP camera’s web connection port number here. When this port number is
changed, you need to change web browser’s port number you used to connect to IP
camera.
For example, if the IP camera’s IP address is 192.168.2.3 and you changed HTTP
port number to 82, please input ‘http: //192.168.2.3:82’ in web browser’s address bar
to access IP camera’s web configuration interface.