ADS-TEC ITC1013 - Manual (Page 24)

Tablet PCs ITC1013
24
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
6 S OFTWARE & DRIVER INSTALLATION
The device will be delivered with a pre-installed Windows operating system on request by
the customer. The drivers required for this are already installed and the operating system
will be enabled by entering the licence information. Should an initial installation be
required, please follow the following steps. With a newer operating system like Windows
XP, the network card and graphics card will properly be recognised during the initial
installation, so that only the touchscreen driver and the soft keyboard must be installed
separately.
Note:
If the hard drive was formatted, the operating system can be reinstalled by using one of
the existing interfaces.
An external keyboard is required for installation.
6.1 C ONFIGURATION C ENTER
C ONFIGURATION
The start page of the Configuration Center provides you with an overview of which ads-tec
applications are installed on the device. Additionally, you can start any of these
applications from the Configuration Center by double-clicking on it.
I NFORMATION
In the Information section, device specific data like the device type, the firmware version
and the serial number are listed. The information you'll find here must be indicated
whenever you need to contact the support department.