3 commissioning, 1 available interfaces – ADS-TEC ITC1013 User Manual

Page 11

Tablet PCs ITC1013

OMMISSIONING

The power supply connection and interfaces of this device are installed at the side of case.
All supply leads and all required data leads have to be connected before starting
commissioning.

Warning:

The device must be switched off before connecting or disconnecting any cables in order

to prevent damage to the electronics!
The device may only be switched on after acclimatising to the ambient temperature in

order to avoid condensate accumulation. Make sure to meet the permissible voltage

requirements for this device.
After switching off and before switching on you must wait for at least 10 seconds.

Note:
The screen of a data cable must always be connected with the connector housing (EMC).
Under the embedded operating system, interfaces must explicitly be enabled and required

drivers must be installed in order to be able to use them.

3.1

VAILABLE INTERFACES