ADS-TEC TT13 User Manual - Manual (Page 22)

Tablet PCs TT13
22
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
P IN -O UT : RS232
PIN-NUMBER SIGNAL NAME
1 DCD
2 RxD
3 TxD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RI
10 NC
The SD Connect cable must be connected so that the red markers match.
For disconnecting the SD Connect cable, it must be pulled rearwards in the area marked in
green. This loosens the snap-in mechanism at the end of the plug.
Note:
The interface is always shown in the network connections, even if the interface is not
available regarding the configuration of the device. Functionality is only given, when a
interface is available.