ADS-TEC OPC8013/8015/8022 - Manual (Page 32)

OPC8013/OPC8015/OPC8022 31
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
8 Software & driver installation
The device will be delivered with a pre-installed operating system depending on what the customer
wants. The drivers required for this, are already installed and the operating system will be enabled by
entering the licence information. Should an initial installation be required, please follow the following
steps. With a newer operating system, the network card and graphics card will properly be recognised
during the initial installation, so that only the touch screen driver and the soft keyboard must be installed
separately.
Information:
If the hard drive was formatted, the operating system can be reinstalled by
using one of the existing interfaces.
An external keyboard is required for installation.
Installing the operating system
The device does not have any integrated CD drive. The installation of the operating system can
therefore only be carried out by using the USB interface.
Procedure for installation:

The boot drive in the system Bios must be switched to USB in order to boot
the device from the USB interface.

Restart the device and insert a Windows CD.

Install Windows and set up the basic data.

With devices including touch screens, the touch screen driver as well as the
soft keyboard should be installed in order to ensure their full functionality.
Touch screen driver installation
Information:
When installing drivers, make certain that this is connected at the default USB
interface intended for the touch screen!
The installation has to be carried out as described below:
The device does not have any integrated CD drive. The installation of the operating system can
therefore only be carried out by using the USB interface.

Follow the on-screen instructions and acknowledge the licence terms and
conditions.

Once the installer has completed the installation, shut down the computer and
restart it subsequently.