Echo 75065 Owners Manual v.2 - Manual (Page 11)

Crary Bear Cat Owners manual 9
Section
understanding how your machine works will help you achieve
the best results when using your EZ trim mower. the following
descriptions define the features and controls of your machine.
Refer to Figure 3.1 for feature locations.
REFER tO ENgiNE OWNERS maNuaL FOR FuRtHER EN-
giNE OPERatiNg iNStRuCtiONS.
3.2 engine ThroTTle
models: 73265, 75065, 75365, 76065
Changes engine speed. move throttle to the FaSt position for
starting. move throttle to the SLOW position to shut engine off.
the engine is intended to run at full RPm. Operate engine with
the throttle in the FaSt position.
3.3 engine choke
models: 73455, 74455
the throttle lever opens and closes the choke valve in the car-
buretor and enriches the fuel mixture for starting a cold engine.
move the throttle lever to the CHOkE position for starting.
When mowing or trimming, the throttle lever should be in the
RuN position.
3 feaTures & conTrols
3.1 fuel shuT off valve
models: all models
the fuel shut off valve opens and closes the connection be-
tween the fuel tank and the carburetor. if the engine is equipped
with a fuel shut off valve, turn it to the ON position for starting.
When the engine is not in use, leave the fuel valve lever in the
OFF position.
3.4 Primer bulb
models: 73265, 75065, 75365, 76065
use when starting a cold engine. Firmly push the primer bulb
3 times before starting.
3.7 self-ProPelled bail
models: 73265, 73455, 75365
Engages the self-propel mode. Pull up the self-propel bail lo-
cated under the handlebar to start the self-propel mode.
3.6 recoil sTarTer
models: 73455, 74455, 75065, 75365, 76065
used to start engine. grasp handle and slowly pull until resis-
tance is felt. after resistance is felt, pull the cord quickly to start
the engine and prevent kickback.
3.5 Trimmer bail
models: all models
to start the trimmer, pull up the trimmer bail located under the
handlebar. When the trimmer bail is engaged, the trimmer disk
is rotating. Release the trimmer bail to stop the mower. Wait
until the trimmer disk has stopped rotating to inspect or service
the mower.
3.8 shifT lever
models: 73265, 73455, 75365
Used to adjust the trimmer speed. Position 1 is the slowest
and position 3 is the fastest. the ground speed ranges from
1-2 mph.
3.9 TilT conTrol handle
models: 74455, 76065
Used to adjust the degree of tilt for the trimmer head and body
when using the Off Center tilt (OCt) feature.
Trimmer bail
self-ProPelled
bail
shifT lever
ThroTTle
TilT conTrol
handle
Trimmer bail
Figure 3.1 - Feature Locations