Echo WT189 Owners Manual - Manual (Page 8)

WHEELED TRIMMER
4
Section
1. Remove the trimmer and handlebar from the shipping box and pallet.
2. Stand handlebar upright. Align the bottom hole on the handlebar with the bottom hole on the handlebar support
channel located on the trimmer and attach with two 5/16" x 1" bolts and nylock flange nuts. DO NOT TIGHTEN
BOLTS AT THIS TIME.
3. Adjust the handlebar height by rotating the handlebar until the top hole on the handlebar is aligned with a corresponding
hole on the handlebar support channel and attach using two 5/16" x 1" bolts and nylock flange nuts.
4. Tighten all remaining bolts.
5. Use the tie provided in the owner's kit to tie the wire to the string holder tube. DO NOT fully tighten, cable needs to
be able to move.
6. Use the tie provided in the owner's kit to tie the kill switch wire to the lower portion of the handle bar.
2
ASSEMBLY
2.1 INSTALL THE HANDLEBAR