Echo SG340 Owners Manual v.4 - Manual (Page 12)

STUMP GRINDER 8
Section
serVICe & maInTenanCe
5
warnInG
disconnect the spark plug wire from the spark plug
and make sure all moving parts are completely
stopped before inspecting or servicing any part of this
machine. The cutting teeth are sharp! use care when
working on the machine to avoid injury.
5.1 maInTenanCe sCHeDule
5.2 CHeCK oIl anD CHanGe FIlTer
Check oil and change the filter as recommended in the engine owner's manual.
serVICe anD maInTenanCe sCHeDule
FreQuenCY
ComPonenT maInTenanCe reQuIreD
reFer To
enGIne
oPeraTor’s
manual
BeFore
eaCH
use
eVerY
8
Hours
eVerY
25
Hours
aIR ClEaNER ChECK aNd ClEaN (1)
aIR INTaKE ClEaN (1)
ENgINE oIl ChaNgE (1)
FuEl FIlTER REPlaCE
SPaRK Plug ChECK CoNdITIoN aNd gaP
ENgINE oIl ChECK/FIll
FuEl TaNK ChECK/FIll
CuTTINg TEETh ChECK ShaRPNESS
all INTERNal aNd
ExTERNal NuTS aNd BolTS
ChECK TIghTNESS
ENTIRE MaChINE ClEaN
dRIvE BElT ChECK
BElT TENSIoN ChECK
BElT/PullEy alIgNMENT ChECK
(1) PERFoRM MoRE FREQuENTly uNdER ExTREMEly duSTy CoNdITIoNS.
as the limited warranty states, failure by the owner to perform normal maintenance will void
the machine's warranty. The aggressive, high-speed nature of stump removal reQuIres THe
owner To PerForm THe aBoVe lIsTeD normal maInTenanCe. special consideration to
maintain and re-torque the CuTTInG TeeTH anD all InTernal anD eXTernal nuTs anD
BolTs is the sole responsibility of the owner. Failure by the owner to do so shall be cause for
denial of warranty.
The items listed in this service and maintenance schedule
are to be checked, and if necessary, corrective action
taken. This schedule is designed for units operating under
normal conditions. If the unit is operating in adverse or
severe conditions, it may be necessary for the items to be
checked and serviced more frequently.
see enGIne owner’s manual For FurTHer
enGIne maInTenanCe anD TrouBlesHooTInG
InFormaTIon.