Fender/wheel assembly adjustment – Echo 99944200563 User Manual

Page 14

X77702093505

ASSEMBLY

99944200563

Fender/Wheel Assembly Adjustment

Dethatcher combing efficiency is best when the full weight of the dethatcher assembly rests on the tines
during operation. Wheel height should be adjusted for 6 - 13 mm (0.25 - 0.50 in.) above ground for
operational stability over uneven grass. Perform wheel height adjustment procedures as follows:

1. Loosen (2) two lower hex head wheel bracket bolts (B).

2. Hold unit in comfortable operating position on a flat surface

and check for wheel to ground clearance of 6 - 13 mm (0.25
- 0.50 in.).

3. Rotate wheels towards tines to reduce ground clearance;

away from tines to increase ground clearance. Tighten bolts
(B).

Do not rotate wheels against tines. Wheels and tines will be
damaged during operation.

If wheel rotation is not sufficient to provide proper wheel height clearance then perform these additional steps:

4. Loosen two upper wheel bracket bolts (C).

5. Slide fender/wheel assembly up drive shaft housing until

proper wheel clearance is achieved. Tighten hex head bolts
(C).

6-13 mm

(0.25-0.50 in.)