Front j-handle assembly – Echo 99944200563 User Manual

Page 12

X77702093505

ASSEMBLY

99944200563

4. Install and seat lower drive shaft end (end with fender/wheel

assembly into gear housing shaft mount. Make sure grass
guide (D) is facing down toward the ground.

5. Rotate and align hole in drive shaft housing with gear

housing shaft hole. Install and tighten alignment screw (A).

6. Tighten gear housing shaft mounting bolt (B).

7. Check for proper inner flex cable (C) engagement into gear

housing adaptor. If flex cable extends out of drive shaft then
cable is not properly engaged. Rotate and push cable end
until lower cable end slides into place in gear housing
adaptor. Cable end will recess approximately 16 mm (5/8
in.) into drive shaft.

Front J-Handle Assembly

1. Remove original front handle assembly. Assemble handle

parts with fasteners and store in a safe place for future
application with other attachments.

2. Remove two (2) J-Handle bracket bolts (A).

Parts Required:

Pro Attachment Series or Split Boom Upper
Shaft and Power Head