Echo CH45540 Owners Manual v.5 - Manual (Page 9)

4.5 INCH CHIPPER
5
ENGLISH
Section
ASSEMBLY
2
1. Move the chipper deflector weldment located inside
the chipper housing to the down position (Figure 2.1).
2. Slide the discharge cap onto the chipper housing,
ensuring that the weldment bolts fit in the notches on
the disk cover (Figure 2.2). Install two 5/16" serrated
flange nuts on the weldment bolts.
3. Insert two 3/8 x 5-1/2" bolts into the bolt holes on the
chipper housing and tighten using 3/8" washers and
3/8" nylock nuts.
Figure 2.2, Discharge cap
Figure 2.1, Chipper deflector weldment
2.1 DISCHARGE CAP ASSEMBLY
Attach the chipper chute to the chipper housing using
four 3/8 x 1" carriage bolts, washers and locknuts (Figure
2.3). Use two bolts on each side. Install with nuts on the
outside.
Figure 2.3, Chipper chute
2.2 CHUTE ASSEMBLY
CHIPPER CHUTE
EXTENSION
3/8” x 1”
CARRIAGE
BOLTS
CHIPPER
CHUTE
Attach the chipper chute extension to the chipper chute
using six 3/8 x 1" carriage bolts, 3/8" washers and 3/8" nuts
(Figure 2.4). Use three bolts on each side.
2.3 ATTACH CHIPPER CHUTE EXTENSION
(CE COMPLIANT MODELS)
Figure 2.4, Chipper chute extension