Echo CH500H Owners Manual v.1 - Manual (Page 18)

5" and 8" Skid Steer Chipper 14
SERVICE & MAINTENANCE
BeFOre iNSPeCtiNg Or ServiCiNg aNy Part OF tHiS MaCHiNe, SHut OFF POWer SOurCe,
diSeNgage tHe HydrauliCS aNd Make Sure all MOviNg PartS Have COMe tO a COMPlete StOP.
Warning
5.8 lubricaTion
Figure 5.8 - Grease every 50 hours
Figure 5.10 - Grease Yearly
Figure 5.4 - Grease every 50 hours
Figure 5.7 - Grease every 50 hours
Figure 5.6 - Grease every 50 hours
Figure 5.9 Same Zerk as Figure 5.4, shown with shield removed.
Figure 5.5 - Grease every 50 hours
lubricate the machine periodically with a lithium-based
grease. extreme working conditions will require more
frequent greasing.
grease the following points every 50 hours of operating
time:
imPorTanT
Polyurea and lithium-based greases are not
compatible. Mixing the two grease types may lead to
premature failure.
noTe
Do not over grease bearings. Overfilling can lead to
excessive heat and/or unseating of the seals. add
grease slowly and under light pressure. Whenever
possible, rotate bearing slowly while lubricating.
50 h
50 h