Echo CH8670H Instruction v.5 - Manual

Instructions
PN 76111-00
Rev. 051710
SUBJECT: PLUS 1 UPGRADE KIT FOR
8 INCH DOMESTIC (PN 76172-00) AND
EUROPEAN (PN 76110-00) CHIPPERS
FITS MODELS: 8" CHIPPERS
CH8670H (76824) AND CH8993H
(76835)
Before inspecting or servicing any part of this machine,
shut off power source, remove key, disconnect the
battery cables and make sure all moving parts have
come to a complete stop.
WARNING
These instructions will describe how to remove the Smart
Relay and install the Plus 1 controller.
REMOVE SNUBBER HARNESS IF ONE WAS INSTALLED
The Plus 1 Controller will not work if a snubber harness was previously installed on your chipper. To check this, look at
the valve assembly (pictured below).
If your valve assembly looks like the one pictured below • , a snubber harness was not installed on your machine
and you may procede with Plus 1 installation.
If your valve assembly does not look like the one pictured below
• because a snubber harness was connected in
the places shown by arrows, you must unplug the connectors, remove the snubber harness, and plug the connectors
back in so that your valve assembly looks like the one shown below.
CONFIRM kILL SWITCH WAS REWIRED
Before installing the Plus 1 controller, confirm that the kill switch has been correctly rewired as described in Service
Bulletin 07-007 (see http://bearcatproducts.com/).