Features & controls – Echo CH911DH Owners Manual v.6 User Manual
Page 13
9 INCH CHIPPER
9
Chipper Chute:
1.
Feeds materials to the chipper blades
for chipping.
Discharge Tube:
2.
Chipped material exits through this
tube. It is adjustable 360 degrees.
Rotor access Cover:
3.
Tilts up to expose rotor.
Drive belt Shield:
4.
Never remove shields when in
use.
Fuel Tank:
5.
Fuel level indicator is located on top.
pintle Hitch:
6.
Always use safety chains when towing.
pivoting Tongue Jack:
7.
Always have in uP position and
clear from ground when moving. When in use, place
in DOWN position on a level surface. Turn handle to
raise or lower wheel.
battery box:
8.
Use group 24 600 CCA min.
belt Engagement pedal:
9.
Used to disengage rotor
assembly drive belt.
Section
FEaTuRES & CoNTRoLS
3
Control panel:
10.
Contains the key switch, throttle control,
Murphy switch and gauges.
Hydraulic Fluid Tank:
11.
Check level of hydraulic fluid
before each use.
Controller Light:
12.
When the light is flashing green,
increase RPM. The feed roller can be shifted into
Forward when the controller light is steady green. See
Section 6 for more information.
Feed Roller Jack:
13.
use the jack to raise the feed roller
for service or maintenance. See Sec. 5.7.
manual Container:
14.
Conveniently holds your
manuals.
Disk Lock and pin:
15.
Use the disk lock to hold the
chipper disk in place when doing any maintenance
work on it. See Sec. 5.2.
Feed Roller Control bar:
16.
Move the feed roller control
bar to begin feeding materials into the chipper.
Feed Roller Speed Control:
17.
Turn clockwise to increase
feed roller speed and counterclockwise to decrease.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17