Echo CH911DH Owners Manual v.6 - Manual (Page 11)

9 INCH CHIPPER 7
ENGLISH
ASSEMBLY
WaRNING
Do not operate this unit without the chipper chute
correctly installed. Rotating cutting blades can cause
serious personal injury.
2.4 aTTaCH EXTENSIoN TRaY
Tilt the extension tray up, so the bottom of the tray is 1.
facing outward (Figure 2.3). Slide the extension tray lips
between the extension hinge and chipper chute lips.
Tilt the extension tray down until the tray rests on the 2.
extension hinge, and the extension tray lips contact the
back of the chipper chute lips.
Insert five 3/8" x 1" carriage bolts (included in owner's 3.
kit) through the extension tray and hinge. Secure the
bolts with washers and nylock nuts from the bottom.
Attach the chute support weldment to the middle hole 4.
of the chipper chute by using the existing bolt.
EXTENSION
TRAY LIP
EXTENSION
HINGE
CHIPPER
CHUTE LIP
Figure 2.3, Attaching the extension tray
2.5 aTTaCH DISCHaRGE TubE
Slide the tube onto the mounting flange on the chipper 1.
frame (Figure 2.4). The discharge clamp should slide
underneath the lip of the flange. Tighten the bolts to
secure it.
Install the second half of the spacer and clamp on the
2.
discharge tube with 3/8" x 1-1/4" bolts and nuts. Rotate
the tube 360 degrees and lock it in place with the lock
pin to make sure it is mounted correctly.
Attach the discharge deflector to the discharge tube.
3.
Connect the cap with 3/8" x 2" bolts through the bottom
hole in the discharge tube. Run these bolts through
the inside of the tube, the cap, washer, knob, and
then nut. Finish bolting the cap to the tube with 3/8"
x 1" bolts through the end hole in the discharge tube
(Figure 2.5).
Fig. 2.4
Fig. 2.5